Idiomas disponibles
Idiomas disponibles
basic_e_d4197_6.fm Page 26 Thursday, November 20, 2003 7:24 PM
3
Keeping the shutter button
pressed halfway, recompose your
shot.
4
Press the shutter button fully.
RECORDING MOVIES
1
Set the mode dial to n and press the power switch.
• The monitor turns on.
• The available recording time on the card that you are using is displayed.
2
Decide the composition of the picture.
• You can use the zoom lever to enlarge your subject.
En
3
Press the shutter button fully to start recording.
• You can adjust the zoom during movie recording. Sound is recorded at
the same time.
• The card access lamp blinks while the movie is stored on the card.
• During movie recording, N lights red.
4
Press the shutter button again to stop recording.
• When the remaining recording time has been used up, recording stops
automatically.
• When there is space in the card memory, the remaining recording time
is displayed, and the camera is ready to shoot.
• During movie recording, the flash and manual focus (MF) are disabled.
• It takes longer to store movies than still pictures.
Note
• The remaining recording time varies depending on the record mode
and the amount of space available on the card.
• This camera cannot play back sound.
ZOOMING IN ON A SUBJECT (OPTICAL ZOOM)
Telephoto and wide-angle shooting are possible at 10× magnification (the
optical zoom limit, equivalent to 42 mm - 420 mm on a 35 mm camera). When
taking still pictures, you can increase zoom magnification to a maximum of
approximately 30× by combining the optical zoom with the digital zoom.
During movie recording, the digital zoom magnification is 2.5×.
Camera movement is likely to occur at higher magnifications. Stabilize the
camera with a tripod, etc. to avoid camera movement.
26 En
F2.8
F2.8
SQ1
SQ1
1600 1200
1600 1200
