Use - Drying - Zanussi ZWT 71401 WA Manual De Instrucciones

Altering an option or a running
programme
It is possible to change some options before the
programme carries them out.
Before you make any change, you must PAUSE
the appliance by pressing the button 8.
Changing a running programme is possible only
by resetting it. Turn the programme selector dial
to O and then to the new programme position.
Start the new programme by pressing the but-
ton 8 again. The washing water in the tub will be
not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme
which is running, the corresponding green pilot
light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
At the end of the programme
The machine stops automatically. Three blinking
0.00 appear on the display and the pilot light of
button 8 goes off. Some acoustic signals
sound.

Use - Drying

Drying only
Warning!
The recommended load size is 3 kg for cottons
and linen, and 1,5 kg for synthetic items.
By pressing Drying Time button it is also
possible to dry up to 4 kg of cotton items
(see the «Drying Programme » table).
Warning!
The water tap must be open and the drain
hose must be positioned in the sink or
connected to the drain pipe.
1. Load the laundry.
www.zanussi.com
to cancel a pro-
If a programme or an option that ends with wa-
ter left in the tub has been selected, the door
remains locked to indicate that the water must
be emptied out before opening the door.
Follow the below instructions to empty out the
water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by press-
ing the relevant button.
4. Press button 8.
At the end of the programme, the door is re-
leased and can be opened. Turn the programme
selector dial to O to switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not in-
tend to carry out another wash, close the water
tap. Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
Stand By: If your laundry is not removed within
10 minutes after the programme is finished, the
back light of the display switches off and the
energy saving system will be enabled. Only the
pilot light of the button 8 is blinking to indicate
that the appliance has to be switched off. By
pressing any button the appliance will come out
from the energy saving status and you can set
another programme or switch the appliance off.
2. Select a spin cycle at the maximum spin
speed allowed for the type of laundry in or-
der to obtain the best drying performances.
3. Select the drying programme for Cottons or
Synthetic in the Drying sector of the pro-
gramme selector dial.
4. If you wish to select a timed drying, press
button 5 until the time you want appears on
the display (see the «Drying Programme»
table). Every time you press this button the
drying time increases by 5 minutes.
Note!
The programme time will automatically in-
crease by some minutes.
5. Press button 8 to start the programme.
After the programme has started, the time
remaining is updated every minute.
17