EGO BCA1220 Manual Del Operador página 24

NOTE: You can skip steps 3 and 4 if the
front handle is already mounted on the
power head shaft.
3. Push the front handle onto the shaft
within the mounting zone between
the threshold ring and the coupler
on the power head shaft (Fig. 11b).
4. Insert the clamping block into the
handle slot (Fig. 11c).
5. Align the groove on the barrier bar
with the corresponding one on the
front handle; hold the bar onto the
front handle; mount the NEW quick-
release lever and tighten the wing
nut. Make sure that the front handle
is positioned upwards and points
toward the top of the rear handle
(Fig. 11d).
24
BRUSH CUTTER ATTACHMENT — BCA1220/BCA1220-FC
11b
Threshold Ring
Front Handle
11c
11d
New Quick-release Lever
Wing Nut
Coupler
Clamping Block