Idiomas disponibles
Idiomas disponibles
CONNECTING THE BRUSH CUTTER ATTACHMENT TO THE POWER HEAD
This brush cutter attachment is designed only to be used with EGO Power Head
PH1400/PH1400-FC/PH1420/PH1420-FC.
WARNING:
power head is running or with the battery installed. Failure to stop the motor and
remove the battery may cause serious personal injury. The brush cutter attachment
connects to the power head by means of a coupler device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob on the power-head coupler.
3. Remove the end cap from the attachment. Align the arrow on the attachment
shaft with the arrow on the coupler (Fig. 10a) and push the attachment shaft into
the coupler until you hear a clear "click" sound. The coupler should be positioned
all the way to the RED LINE labeled on the shaft for the attachment shaft to be
properly mounted into place (Fig. 10b)
10a
Red Line
Attachment Shaft
10b
22
BRUSH CUTTER ATTACHMENT — BCA1220/BCA1220-FC
Never install, remove, attach or adjust any attachment while the
Wing Knob
Arrow on the Attachment Shaft
Arrow on the Coupler
Red Line
Power-head Shaft
Shaft-release Button
