EN
1. Put the machine on a flat and smooth surface.
2. Pull the rotating button and turn the rear handle.
3. Release the rotating button until it locks into position.
10
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
10.1
CLEAN THE MACHINE
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
•
Use a moist cloth with a mild detergent to clean the
machine.
•
Clean all moisture with a soft dry cloth.
•
Use a small brush to clean the air vents.
10.2
LUBRICATE THE BLADE
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
•
Put the machine on a flat and smooth surface.
•
Use a soft cloth to clean the blades and a brush to remove
more dirt.
•
Use a light layer of oil to lubricate the blades along the
top edge of the blade.
We recommend to use the non-pollutant type oil.
11
STORE THE MACHINE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
CAUTION
CAUTION
WARNING
WARNING
NOTE
NOTE
English
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
12
TROUBLESHOOTING
Problem
The motor does
not start when you
pull the trigger.
The machine
smokes during op-
eration.
The motor is on,
blades do not
move.
There is too much
noise and/or vibra-
tion during opera-
tion.
13
TECHNICAL DATA
Voltage
No load speed
Blade length
Cutting capacity
Weight (without battery
pack)
Battery model
8
Possible cause
Solution
Make sure that
The battery pack is
you tighlty install
not installed tight-
the battery pack in
ly.
the machine.
The battery pack is
Charge the battery
out of power.
pack.
1. Immediately
stop the ma-
chine.
The machine has
2. Remove the
damage.
battery pack.
3. Speak to serv-
ice center.
Do not use the ma-
The machine has
chine and speak to
damage.
service center.
Remove battery
The blades are
pack then clear
blocked.
blockage from the
blades.
1. Stop the ma-
chine.
2. Remove the
battery.
The parts are loos-
3. Inspect for
en.
damage.
4. Check and
tighten loose
parts.
Do not use the ma-
The parts have
chine and speak to
damage.
service center.
80 V
3400(±10%) SPM
24'' (610 mm)
3/4''
8.37 lbs
2901302 and other BAB
series