Idiomas disponibles
Idiomas disponibles
Overheat protection for tool
When
the
tool
is
automatically and the battery indicator shows following
state. In this situation, let the tool cool before turning the
tool on again.
Battery indicator
015176
Reversing switch action
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
B
B
1
A
015164
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the
position (A side) for clockwise rotation or
the
position (B side) for counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
CAUTION:
When not operating the tool, always set the reversing
switch lever to the neutral position.
Depth adjustment
B
1
A
B
015165
The depth can be adjusted by turning the locator. Turn it
in "B" direction for less depth and in "A" direction for
overheated,
the
tool
On
Off
Blinking
Tool is overheated
1. Reversing
switch lever
1. Locator
A
more depth. One full turn of the locator equals 2 mm
(1/16") change in depth.
stops
3 mm (1/8")
1
011827
Adjust the locator so that the distance between the tip of
the locator and the screw head is approximately 3 mm
(1/8") as shown in the figures. Drive a trial screw into
your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue
adjusting until you obtain the proper depth setting.
Hook
CAUTION:
Always remove the battery when hanging the tool
•
with the hook.
Never hook the tool at high location or on
•
potentially unstable surface.
015170
The hook is convenient for temporarily hanging the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the bit
1
015166
7
1. Locator
1. Hook
1
1. Locator
