Idiomas disponibles
Idiomas disponibles
H
1
STEP 2
3
STEP 3
5
STEP 5
7
9
STEP 7
STEP 9
11
STEP 10
13
STEP 12
STEP 11
4
86
REPLACEMENT OF THE WICK
2
2
L
ENSURE THAT THE HEATER IS OFF AND COMPLETELY
COOL BEFORE STARTING TO REPLACE THE WICK.
1a. Open the tank cover and remove the fuel tank .
1b. Remove the batteries to prevent possible burns.
1c. Open the front grille and remove the combustion cham-
4
1d. Remove the knurled wick adjustment knob 2 by pulling
2.
3.
STEP 4
4.
6
5.
6.
7.
8.
9.
STEP 6
8
10. The replacement wick has a black line. Fold the new
11. The black line on the outside of the wick should match
STEP 8
12. Replace the wick and holder in the burner tank. Rotate
10
13. It is recommended to reinstall the knurled wick adjust-
14. Insert the pinion at the other end of the wick control
12
14
STEP 14
ber 4.
it straight out.
Unscrew the 5 screws, 2 from the back and 1 from the
right side and 2 from the left side of the cabinet .
Remove the cabinet by pulling it straight up.
Remove the screw on the wind cover K.
Remove the wind cover.
Remove the automatic ignition assembly by unscrewing
2 screws.
Unscrew 4 wing nuts.
Remove the wick adjuster assembly.
Remove the wick from the holder by folding it toward
the center loosening it from the sharp metal teeth on
the inner surface of the holder, and slide it out.
wick and slide into the holder.
the top edge of the holder. Then press it against the
teeth inside the holder to obtain a firm grip.
90 degrees left and right as well as up and down until
the wick slides freely. Check to see that the gasket is still
in place on the burner tank.
ment knob 2 for easier assembly.
shaft into the top part of the rack of the wick holder.
This step can be easily carried out if the wick holder is
raised.
