Idiomas disponibles
Idiomas disponibles
to each other; jumper 4-5 is located in the lower area
GB
of the terminal board.
3. Position the wires N and
diagram (see figure) and proceed with the
connection process, tightening the terminal screws
as far as possible.
4. Position the remaining wires on terminals 1-2-3
and tighten the screws.
5. .ix the power supply cable in place by fastening
the cable clamp screw.
6. Close the terminal board cover by tightening the
screws V.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the
load indicated on the appliance data plate (see
Technical data table).
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum
contact opening of 3 mm installed between the
appliance and the mains. The circuit-breaker must be
suitable for the charge indicated and must comply with
N.C 15-100 regulations (the earthing wire must not be
interrupted by the circuit-breaker). The supply cable
must be positioned so that it does not come into
contact with temperatures higher than 50°C at any point.
Before connecting the appliance to the power
supply, make sure that:
• The appliance is earthed and the plug is compliant
with the law.
• The socket can withstand the maximum power of
the appliance, which is indicated by the data
plate.
• The voltage is in the range between the values
indicated on the data plate.
• The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it.
Do not use extension cords or multiple sockets.
Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
The cable must not be bent or compressed.
The cable must be checked regularly and replaced
by authorised technicians only.
The manufacturer declines any liability should
these safety measures not be observed.
Only available in certain models.
*
14
$
as shown in the
TABLE OF CHARACTERISTSICS
Dimensions
34x41x38
Oven HxDxW
Volume
53 l
Useful
width 42 cm
measurements
depth 44 cm
relating to the oven
height 17 cm
compartment
Voltage and
see data plate
frequency
Ceramic hob
Front Left
1200 W
Back Left
1800 W
Back Right
1200 W
Front Right
1800 W
Max. ceramic hob
consumption
6000 W
Directive 2002/40/EC on the label of
electric ovens.
Standard EN 50304
Energy consumption for Natural
ENERGY LABEL
convection – heating mode:=
Traditional mode;
Declared energy consumption for
Forced convection Class – heating
mode: K Baking mode.
This appliance conforms to the following
European Economic Community
directives: 2006/95/EEC dated 12/12/06
(Low Voltage) and subsequent
amendments - 89/336/EEC dated
03/05/89 (Electromagnetic
Compatibility) and subsequent
amendments - 93/68/EEC dated
22/07/93 and subsequent amendments.
2002/96/EEC
