Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4.0 MX2 B
3
Starting on one side, slide/adjust the Cane Clamp (B) to the desired
height/ position along the back cane and secure it in place.
Note: The final back height may be further adjusted/fine tuned following
installation of the MX2 back shell onto the mounting plates
4
From a fixed point on the wheelchair (e.g. seat frame/rigidizer bar) measure
the height of the first cane clamp assembly, and secure the second cane
clamp at the same height on the opposite back cane- see Fig. 6 below.
Note: Ensure installed Cane Clamps/Mounting plates are aligned parallel
with each other.
MX2 Cane Clamp/Mounting Plate Height Adjustment
B
Fig. 6
4.6 Installing the MX2 Back onto Quick-Release Hardware
WARNING! Improper mounting pin set-up may cause damage to the
back pan and/or the mounting plates. Ensure sufficient space is provided
between the mounting plate and the head of the mounting pins (a minimum
gap of 1/8" (3mm) is recommended).
WARNING! NEVER use loctitie on mounting hardware; Non-metal
components may degrade and become brittle (break) if contaminated.
IMPORTANT! Unless otherwise necessary, always ensure that adjustments
are made symmetrically on the left and right mounting brackets.
- R R
ACK
EMOVABLE
Install Cane Clamps at the same
height and parallel to each other
REAR VIEW
(Wheelchair with back removed)
M
I
OUNT
NSTALLATION
B
Tabla de contenido
