Idiomas disponibles
Idiomas disponibles
Pull out the power connector from the housing through its designated recess.
C)
Use the base plate as a template for the drill holes. Mark the drill holes and then drill them.
Wear safety glasses and hearing protection! Insert the included dowels (2x Ø8mm) into the
holes.
D)
Connect the power supply (220 - 240 V~, 50/60 Hz). CAUTION! Only have this done by a
qualified specialist!
E)
Properly place the power connector in the housing again. Use screws (2x Ø5x50mm) to
secure the base plate to the ground. During the process, ensure that the power line is
properly guided through its designated recess.
F)
Turn on the fuse again.
Design version 2 (with earth spike)
A)
Switch off the fuse.
B)
Screw the earth spike to the bottom of the housing.
C)
Pull out the power connector from the housing through its designated recess.
D)
Connect the power supply (220 - 240 V~, 50/60 Hz). CAUTION! Only have this done by a
qualified specialist!
E)
Properly place the power connector in the housing again. Vertically insert the earth spike into
an even, adequately firm surface. Ensure that the earth spike sits firmly in the ground and
cannot fall over.
F)
Turn on the fuse again.
Design version 3 (with base plate and earth spike)
A)
Switch off the fuse.
B)
Screw the base plate and the earth spike onto the bottom of the housing.
C)
Pull out the power connector from the housing through its designated recess.
D)
Connect the power supply (220 - 240 V~, 50/60 Hz). CAUTION! Only have this done by a
qualified specialist!
E)
Properly place the power connector in the housing again. Vertically insert the earth spike into
an even, adequately firm surface. Ensure that the earth spike sits firmly in the ground and
cannot fall over.
F)
Turn on the fuse again.
MAINTENANCE AND CARE INSTRUCTIONS
The product is maintenance-free. There are no serviceable parts inside the product; never
disassemble the motor unit.
Check all the parts for signs of wear. Do not continue to use the product if you find any defects.
Parts should only be replaced with original spare parts, and by a specialist, in accordance with the
manufacturer's specifications.
Do not use cleaners or detergents containing solvents; substances such as bleach can damage the
product. Use a slightly damp towel to clean the housing and a few drops of mild detergent in case
of heavier soiling.
Never direct a stream of water, such as a high-pressure cleaner, towards the product.
Disconnect any connected consumers from the product before any cleaning.
11
www.DEUBAXXL.de
