Idiomas disponibles
Idiomas disponibles
1. Determine which visor corresponds with the driver and passenger side rear doors. Start on
either side of the vehicle as the same steps are repeated for the other side.
2. Lower rear windows into the down
position. Test fit visors in window
track to determine proper alignment.
Figure 5
4. Remove the tape liner and place the rear visor into the channel. Place inner corner in position
and swing rear up being careful not to contact the weather-strip with the tape until in
position.
5. Once the visor is installed grab 2 of the short in-channel support clips. The clips install in the
channel directly on the backside of the visor.
6. The clips should be installed in the locations indicated in Figure 7. The center of the clips
should be at the bottom of the visor.
Figure 7
7. Roll up the window until the visor is fully seated. Allow 12-24 hours for the tape to cure
before use.
8. Repeat steps 2-7 for the other rear visor.
Putco guarantees its Stainless Steel and Aluminum products against defects in workmanship and material for as long as you own your vehicle.
All painted products have a 90 day warranty on the painted surface. Any defects resulting from faulty material or workmanship will be warranted
by Putco and repaired or replaced at our discretion. Putco assumes no extra labor costs. Damages caused by freight carriers, improper
installation, misuse, collision, or neglect will not be warranted by Putco.
08/05/2020 NN
Rear Visor Installation
3. Remove visor and wipe down
weather-strip with rubbing alcohol that
meets window visor.
Figure 6
Clip Locations
Page 3 of 3
F480025I
F480025I
