Idiomas disponibles
Idiomas disponibles
8. Once the visor is installed grab 2 of the Tall in-channel support clips. Figure 3 Shows which
clips to use for which visor. The clips install in the channel directly on the backside of the
visor.
9. The clips should be installed in the locations seen in Figure 4. At the rear location the center of the
clip should be at the end of the visor. At the front location the clip should be near the bottom of the
visor.
10. Once the clips are installed roll up the window and allow the visor to cure for 12-24 hours
before use.
11. Repeat steps 3-10 for the other front visor
Putco guarantees its Stainless Steel and Aluminum products against defects in workmanship and material for as long as you own your vehicle.
All painted products have a 90 day warranty on the painted surface. Any defects resulting from faulty material or workmanship will be warranted
by Putco and repaired or replaced at our discretion. Putco assumes no extra labor costs. Damages caused by freight carriers, improper
installation, misuse, collision, or neglect will not be warranted by Putco.
08/05/2020 NN
Figure 3
Clip used for
the rear visor
Clip Locations
Figure 4
Page 2 of 3
F480025I
Clip used for
the front visor
F480025I
