PUTCO 470300 Instrucciones De Instalación

HOOD SHIELD INSTALLATION INSTRUCTIONS
Congratulations on your purchase of a high quality PUTCO product. Should you need
any application or technical assistance feel free to call us at: 1-800-247-3974
Monday-Friday 8:00 a.m. - 5:00 p.m. (Central Standard Time)
Please read all instructions before installation and to check to see that all parts are included.
Kit Contents:
Description
Hood Shield
Screw Plug (A)
#12 Sheet Metal Screw (B)
¼" Flat Washer (C)
Rubber Bump-on
Note: Rubber Bump-on is required for this
application to prevent damage to the hood.
Installation Temperature:
•
60˚- 110˚F (16˚- 43˚C)
1. Clean and open the hood. Make sure that the hood is
free of any dirt or debris.
2. Trial fit Hood Shield by aligning the mounting holes of
the Hood Shield with the matching holes in the hood.
(Fig. 1)
3. Attach the screw plug (A) to the two inside hood slots.
(Fig. 1)
4. Partially peel the 3M tape backing down 2" on each
side. (Fig. 2)
5. Clean grille area where the 3M tape will be applied to
using Isopropyl Alcohol. Re-fit Hood Shield to the
factory hood by aligning the Hood Shield Slots up with
the factory slots. (Fig. 1) Attach Hood Shield to the
hood by placing a washer (C) on each of the mounting screws (B) and inserting the
screws through the Hood Shield slots and into the plastic screw plug (A). Tighten
screws just enough to hold hood shield in place.
6. Center Hood Shield on the hood and tighten screws using a Philips screw driver until
snug. Close hood carefully to check the fitment. If the Hood Shield is not centered
loosen the screws and adjust until it is centered and re-tighten the screws. Once the
Hood Shield is centered remove the 3M tape backing and apply even pressure for
30 seconds.
7. Attach rubber bump-on to the factory hood where the corners of the Hood Shield
are closest to the hood. (Fig. 3) Clean area first with isopropyl alcohol and
remove adhesive backing from bump-on and apply to hood.
LIMITED 1 YEAR WARRANTY
Putco guarantees it's Stainless Steel and Aluminum products against defects in workmanship and material for as long as you own
your vehicle. All painted products have a 90 day warranty on the painted surface. Any defects resulting from faulty material or
workmanship will be warranted by Putco and repaired or replaced at our discretion. Putco assumes no extra labor costs. Damages
caused by freight carriers, improper installation, misuse, collision, or neglect will not be warranted by Putco. Putco is not liable for
any vehicle damage resulting from the installation of our Hood Shield.
www.putco.com
Contact your PUTCO dealer for other quality accessories.
Qty.
1
2
2
2
2
2009-2013 Ford F-150
A B
Figure 1
Figure 2
2/26/2013
470300 & 570300
C
Figure 3
=
Bump-on
Page 1 of 3