Oral-B iO Manual Del Usuario página 10

Accessories
(depending on model)
Charging Travel Case (h)
• To charge your handle (5) place it in the charg-
ing travel case (h) and connect it to an electric
outlet, using the extra power supply (h2) pro-
vided. The power supply may be used for all
global mains voltage ranges (100 – 240V).
• The flashing light (h1) of the charging travel
case indicates that the handle is charging.
Once the handle is fully charged the light turns
off. A full charge typically takes 6 hours.
• The outer and inner case should be cleaned
with a damp cloth only. Make sure that the
handle and brush head are completely dry
before storing in the travel case.
Note: Clean stains on travel case surface imme-
diately. Store travel case in a clean and dry place.
Travel Case (g)
Store the clean and dry toothbrush/brush heads
in the travel case (g).
The outer and inner case should be cleaned with
a damp cloth only.
Note: Clean stains on travel case surface imme-
diately. Store travel case in a clean and dry place.
Brush head holder stand (f) / Brush head
holder with cap (e)
You may store your cleaned brush heads on the
pins of the brush head holders. Make sure brush
heads are dried before placing them in the holder
and/or closing the cap. Brush head holders and
cap are dishwasher-safe.
Zipper Pouch / Magnetic Pouch
Store the clean and dry toothbrush/brush heads
in the zipper pouch.
The outer and inner case can be cleaned under
running water.
Store the clean and dry toothbrush along with the
brush head holder (e) in the magnetic pouch. Make
10
sure brush heads are dried before placing them into
the holder and/or closing the cap. The outer and
inner surfaces can be cleaned under running water.
Store pouches in a clean and dry place.
Note: Clean stains on pouch surfaces immediately.
Subject to change without notice.
Environmental Notice
Product contains batteries and/or
recyclable electric waste. For
environment protection do not
dispose in household waste, but
for recycling take to electric
waste collection points provided in your country.
Battery removal at the end of
the product's useful life
Do not disassemble the product except when dis-
posing of the battery. Run down battery before
removing. When taking out the battery for dis-
posal, use protective clothing (gloves, safety
glasses, etc.) to omit skin contact whilst leaking
batteries. Use caution not to short the positive (+)
and negative (–) terminals. Insulate terminals
(e.g. with tape) and put the battery in a plastic
bag for disposal.
1
4
2
45°
3
6
Li-ion
5 7