Power Connection - Work Pro W WFS 1200 Manual De Uso

EN
Fig. B4

POWER CONNECTION

1. Connect all power cables between the follow spot and external ballast and supply the external ballast to
power source
2. WARNING !!! Please, not supply the power to the device until the earth wire of the device will be
connected.
3. The ballast is connected to the follow spot through the joint cable (Fig. C1). This cable has male and female
end. Connect each one in the suitable connection (fig. C2).
WARNING !!! Please, notice that there should have enough space to disperse the heat of the external
ballast (Fig. C3)
Fig. C1
STARTING
1. Ensure that the power cables are connected according to the requirements and the lamp is correct installed.
2. The red power lamp indicator in the ballast should light when the power switch is turned on. (fig. C4)
3. The green indicator lamp in the ballast should light when the switch on the follow spot is pressed (fig. C5),
simultaneously, the lamp starts to light (the brightness of the lamp will become the maximal after 2 minutes).
4. Please, press the start switch on the follow spot when the lamp need turn off (fig. C5). This switch is a self-
lock switch, one push for on and another for off), the lamp will be off but the cooling fan will work, the indicator
lamp is light. When the power switch in the ballast is off, the device is completely turned off.
WARNING !!! When the lamp is turned off, please wait about 15 minutes before turn on the lamp again,
if it is started at once, the life of the trigger will be shortened.
Fig. C4
Fig. B5
Fig. C2
Fig. C5
PAG. 3
User Manual/Manual de Instrucciones
Fig. B6
Fig. C3
WFS 1200