Idiomas disponibles
Idiomas disponibles
Instructions on service and maintenance:
- Regularly cleaning the machine, especially the
adjusting devices and guides, constitutes an
important safety factor.
- Only original MAFELL spare parts and accessories
may be used. Otherwise the manufacturer will not
accept any warranty claims and cannot be held
liable.
4
Layout
4.1 Depicted components
(see Fig. 1 and 2)
(1)
Depth stop
(2)
Handle depth stop
(3)
Scale for the depth stop
(4)
Optical fibre speed adjustment
(5)
Speed push button
(6)
Speed reduction button
(7)
Power-on lock
(8)
Handle
(9)
Connecting cable
(10)
Switch trigger
(11)
Hose connector
(12)
Wing screw for support foot
(13)
Wing screw to fasten parallel guide
fence,
deflector and template guides
(14)
Base plate
(15)
Revolving depth stop with grub screws
(16)
Fine adjustment depth stop
(17)
Cam lever
(18)
Column clamping lever
(19)
Handle
5
Setting / adjustment
5.1 Mains connection
Prior to commissioning make sure that the mains
voltage complies with the operating voltage stated on
the machine's rating plate.
extraction
adapter,
5.2 Chip and dust extraction
Chips arising during milling as well as hazardous dusts
arising from certain materials can be extracted by
means of a commercial vacuum cleaner or with an
external dust extractor.
To do so, attach the hose end of the vacuum cleaner
to the hose connector 11 (see Fig. 2) of the base plate.
For improved extraction, an additional extraction
adapter can be used (included in the scope of supply).
When working with a guide rail, an extraction adapter
with height compensation (included in the scope of
supply) is used.
When machining edges, a chip deflector which guides
any arising chips away from the operator and improves
extraction can be additionally mounted. The chip
deflector is included in the scope of supply.
5.3 Clamping of milling cutters
The machine is as a standard equipped with a
precision collect Ø 8 mm. It is possible to fasten milling
cutters with corresponding shaft diameter in this collet.
chip
Clamping
•
Set the machine to the topmost position by
actuating the column clamping lever 18 (Fig. 2).
•
Open the tool clamping lever 20 (Fig. 3)
completely downwards.
•
Place the machine on its head or put it down on
its side.
•
Push the clean milling cutter shaft into the open
collet up to the minimum clamping depth
marking. If there is no marking for the minimum
clamping depth, push at least three third of the
shaft length of the milling cutter shaft into the
open collet.
-25-
Danger
It is imperative to pull the mains
plug before replacing the milling
cutter. Place the machine on its
head or put it down on its side. Do
not set the machine down on the
side with the hose connector! This
can result in damage to the
workpiece.
