Kohler K-99695 Guía De Instalación Y Cuidado página 13

Valve Settings (cont.)
Select the settings for each shower outlet for your system configuration.
If applicable, click on [Valve 2] to select the outlets for the second valve.
Complete the Installation
Once components have been configured, test for functionality. Verify that each component is
operating as intended.
For troubleshooting information for each system component, refer to the guide on the product page
at www.us.kohler.com.
Troubleshooting
IMPORTANT! Turn off the power before performing any maintenance.
NOTE: For service parts information, visit your product page at www.kohler.com/serviceparts.
This troubleshooting guide is for general aid only. For service and installation issues or concerns, call
1-800-4KOHLER.
Controller Troubleshooting Table
Symptoms
1. System stops working and
the status LED is solid
red.
2. System stops working and
the Status LED is OFF.
3. Components are
sometimes not on the
menu, even though they
are connected to the
controller.
Interface Troubleshooting Table
Symptoms
1. Interface is not lit.
Kohler Co.
Probable Cause
A. System failure.
A. Power supply failure.
B. Incorrect wiring of the AC
power supply.
A. Damaged cables or incorrect
cable installation.
B. Power fluctuation.
C. The device is not installed
correctly.
Probable Cause
A. Controller is not plugged into
the electrical outlet.
B. Interface cable connections may
be loose or disconnected.
C. Circuit breaker has been
tripped.
D. The controller may require
resetting.
13
Recommended Action
A. Reboot the controller by
disconnecting the AC power from
the wall outlet. If the status LED
remains a solid red after reboot,
replace the controller.
A. Reboot the controller by
disconnecting the AC power from
the wall outlet. If there is no
change after reboot, replace the
power supply.
B. Verify that the controller was
installed per the installation
manual. Make sure AC power is
present at the outlet the controller
is plugged into.
A. Check all wiring connections.
B. Verify that the devices are
connected to a stable power supply.
C. See peripheral device owners
manual.
Recommended Action
A. Plug the controller into an electrical
outlet.
B. Check all interface cable
connections.
C. Reset the circuit breaker.
D. Disconnect and reconnect the
controller power supply from the
electrical outlet.
1218131-2-D