Idiomas disponibles
Idiomas disponibles
Safety measures concerning the hydraulics
53) At the moment of connecting the hydraulic tubes to the
hydraulic system of the tractor, make sure that the hydraulic
systems of the operating machine and the tractor are not
under pressure.
54) For the operative hydraulic connections between tractor and
operating machine, the sockets and plugs should be marked
with colours to distinguish them, to avoid them being used
wrongly. There would be a danger of accident if the
connections were to be swapped round.
55) The hydraulic system is under high pressure; because of
the accident risk, when searching for leakage points special
auxiliary instruments should be used.
56) Not to never carry out the search losses with the fingers or
the hands. The liquids that exit from the holes can be nearly
not visible.
57) During transport by road the hydraulic connections between
tractor and operating machine should be disconnected and
secured to the support provided.
58) Do not use vegetable oils under any circumstance. These
could cause a risk of damage to the cylinder gaskets.
59) The operating pressures of the hydraulic system should be
between 100 bars and 180 bars.
60) Never exceed the indicated hydraulic system pressure levels.
61) Check that the quick hook-ups are coupled correctly; parts of
the system could get damaged if they are not.
62) Oil escaping at high pressure can cause skin injury with the
risk of serious wounds and infection. Call a doctor
immediately if such an incident occurs. If the oil with surgical
means is not removed quickly, can take place serious
allergies and/or infections. Therefore, the installation of
hydraulic components in the tractor driver's cab is strictly
forbidden. All the components of the system should be
positioned carefully to avoid parts being damage during use
of the equipment.
63) In case of participation on the hydraulic system, to unload
the hydraulic pressure carrying all the hydraulic commandos
in all the positions some times after to have extinguished the
motor.
cod. G19502561
USE AND MAINTENANCE
Maintenance in safety
Durante le operazioni di lavoro e manutenzione, utilizzare gli
idonei dispositivi di protezione individuale (es.):
Overalls
64) Do not proceed with maintenance and cleaning if the power
take-off has not been disconnected first, the engine power
off, the hand brake pulled and the tractor blocked with a
wooden block or stone of the right size under the wheels.
65) Periodically check that the bolts and nuts are tight, and if
necessary tighten them again. For this it would be advisable
to use a torque wrench, respecting the values of 53 Nm for
M10 bolts, resistance class 8.8, and 150 Nm for M14 bolts
resistance class 8.8 (Table.1)
66) During assembling, maintenance, cleaning, fitting, etc., with
the seeding machine raised, place adequate supports under
the equipment as a precaution.
67) The spare parts must correspond to the manufacturer's spe-
cifica-tions. Use only original spares.
g
Gloves
Shoes
Goggles
ENGLISH
Helmets
Table 1
43
