Idiomas disponibles
Idiomas disponibles
a) Prepare freshly cut branches of appropriate length, so as to facilitate
unobstructed spinning by the rubbers over the mesh.
CAUTION! While spinning, the rubbers will push the branches against the mesh
and drag them along it. The cut leaves fall into the bowl whilst fruits, stalks etc.
remain on the mesh.
b) Place the bowl on level, stable, clean, and dry surface (1).
c)
Place mesh with blades over the bowl (2).
d) Place branches evenly on the mesh.
e) Place cover on the bowl with mesh (3).
NOTE: When attaching the cover, align the cover fastening nut with the gearbox
shaft on the spiral grate!
f)
Attach the crank on the top of cover (4).
g) Turn the crank of the device in a clockwise direction (5). Turning the crank will
move the rubbers under the cover.
h) Continue turning the crank until the desired results are obtained.
i)
After finished work with the device, empty the bowl and mesh.
j)
The disassembly is done in reverse order to its assembly.
INSTALLATION / CHANGING THE BLADE
a) CAUTION! It is forbidden to change blades without protective gloves on! Make
sure you are properly equipped with personal protective equipment before
replacing blades!
b) The device is adapted to the installation of crosswise or lenghtwise blades (A,
B).
c)
The blades are located on the mesh of the device.
d) To change the blade, turn the mesh with blades so that the blades are facing
upwards.
e) Unscrew and remove the nut securing the blades to the mesh (C).
f)
Slide out the worn blades, and install new ones in their place.
g) Secure by tightening the nut.
3.4. Cleaning and maintenance
a)
Pull out the mains plug before each cleaning and when the unit is not in use.
b)
In the case of leaves intended for brewing, for example, only mild cleaning
agents designed for cleaning food contact surfaces may be used to clean the
device.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
