Idiomas disponibles
Idiomas disponibles
Transmission system cleaning
Filling detergent
Make sure there is enough detergent in the detergent bottle.
Select the function of "Add Detergent" in the main menu
Seleccione la función "Añadir detergente" en el menú
principal.
Set the amount of the detergent to be filled (the setting
range: 0.00-0.50 L).
Note: Before filling the detergent, you need to calibrate the
cleaning speed (see "sensor calibration" content).
The default value of the unit is 0.20L and the maximum value
is 0.50L.
Press ENTER key after the amount to be filled is confirmed.
The detergent will be pumped into the hose.
After the filling operation is finished, the system will automa-
tically pop-up print menu.
Press ENTER key select print.
Press RETURN key to cancel printing.
Then, the screen will show a 10 minutes countdown.
Turn on the engine of the vehicle.
Transmission system cleaning
Once you start the engine, the fluid will circulate from the
machine to the vehicle's transmission system.
In order to speed up the circulating process, it is advisable to
perform a gear-shift operation
The running time for each gear-shift should be kept for
about 1 minute.
When the vehicle engine is running with high-speed, the
speed should be more than 60 km/h to ensure the effect of
cleaning).
Finish cleaning
After 10 minutes, please turn off the engine to end the
cleaning process
Transmission liquid exchange
When you need to exchange the transmission fluid, please
put 0.5L inside the new fluid tank.
Before putting the liquid, make sure that the new fluid tank
and the hoses are clean.
Check if the pipelines are well connected.
Start the vehicle to warm up the fluid inside the transmission
to normal temperature.
As shown in figure below, you can directly input the fluid
amount to be changed or consult correct amount depending
on the type of vehicle.
· 18 ·
REF.54290
