Jandy AquaLink 40012 Manual De Instalación Y Operación página 4

Idiomas disponibles

Idiomas disponibles

ENGLISH
Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
All electrical work must be performed by a licensed electrician and
conform to all national, state, and local codes. When installing and
using this electrical equipment, basic safety precautions should
always be followed, including the following:
To reduce the risk of injury, do not remove the suction fittings of your spa or hot tub. Never
operate a spa or hot tub if the suction fittings are broken or missing. Never replace a suction
fitting with one rated less than the flow rate marked on the equipment assembly.
Risk of electric shock, which could result in severe injury or death - Install the
power center at least five (5) feet (1.52 m) from the inside wall of the pool and/or hot tub
using non-metallic plumbing. Canadian, Australian, and European installations must be at
least three (3) meters from the water.
• Children should not use spas or hot tubs without adult supervision.
• Do not use spas or hot tubs unless all suction guards are installed to prevent body and
hair entrapment.
• People using medications and/or having an adverse medical history should consult a
physician before using a spa or hot tub.
A terminal bar marked "GROUND" is provided within the power center. To reduce the risk of
electrical shock, connect this terminal bar to the grounding terminal of your electric service
or supply panel with a continuous copper conductor having green insulation and one that is
equivalent in size to the circuit conductors supplying this equipment, but no smaller than no.
12 AWG (3.3 mm
2
(8.4 mm
) copper wire to any metal ladders, water pipes, or other metal within five (5) feet
2
(1.52 m) of the pool/spa. In Canada, the bonding wire must be minimum 6 AWG (13,3 mm
When a Power Center is used to power or switch an underwater luminaire, suitable Ground
Fault Circuit Interrupter (GFCI) protection for the lighting circuit shall be provided in the
field. The conductors on the load side of the ground-fault circuit-interrupter shall not
occupy conduit, boxes, or enclosures containing other conductors unless the additional
conductors are also protected by a ground-fault circuit-interrupter. Refer to local codes for
complete details.
To avoid injury ensure that you use this control system to control only packaged pool/spa
heaters which have built-in operating and high limit controls to limit water temperature for
pool/spa applications. This device should not be relied upon as a safety limit control.
Page 4
Jandy
AquaLink
®
®
). In addition, a second wire connector should be bonded with a no. 8 AWG
Wireless Handheld Remote | Installation & Operation Manual
WARNING
).
2
loading

Este manual también es adecuado para:

0 aqwhr18