Idiomas disponibles
Idiomas disponibles
ENGLISH
4.1
Menus and Functions
If the wireless handheld remote is part of an AquaLink
PDA system, additional setup and programming options
are available from the remote user interface (UI).
If the wireless handheld remote is part of an AquaLink
RS or Z4 system, setup and programming will need to
be performed from the system UI. The wireless handheld
remote can then be used to activate and deactivate the
equipment, programs and settings.
4.2
Pool Mode/Spa Mode
This combination setting will start the filter pump at the appropriate
speed and rotate automatic valves to the correct return. If SET TEMP
has been enabled the heater will also engage and heat the pool or
spa to the temperature set point.
4.3
Pool Heater/Spa Heater
Activates or deactivates heater. When heater is active, water will be
heated to temperature set point established for the pool or spa. The
temperatures can also be adjusted manually using the arrow keys to
adjust the temperature value up or down.
Page 14
Jandy
AquaLink
Wireless Handheld Remote | Installation & Operation Manual
®
®
POOL MODE
Combination setting will activate
the following equipment:
- Filter Pump
- Automatic Valves
(Rotate for pool return)
- Heater
(Will heat to set point for pool)
POOL HEATER
Activates heater and
will heat to pool set
temperature.
Temperature can
also be set manually
using the up and
down arrow buttons.
SPA MODE
Combination setting will activate
the following equipment:
- Filter Pump
- Automatic Valves
(Rotate for spa return)
- Heater
(Will heat to set point for spa)
SPA HEATER
Activates heater and will
heat to spa set
temperature.
Temperature can
also be set manually
using the up and
down arrow buttons.
