Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL OPERATION
FUNCTIONS:
•
With the slide switch in the REMOTE position, the system will only
operate if the remote receiver receives commands from the trans-
mitter.
•
Upon initial use or after an extended period of no use, the ON but-
ton may have to be pressed for up to three seconds before activat-
ing servo motor. If the system does not respond to the transmitter
on initial use, see LEARNING TRANSMITTER TO RECEIVER.
•
With the slide switch in the ON position you can manually turn ON
the system.
•
With the slide in the OFF position, the system is OFF.
•
It is suggested that the slide switch be placed in the OFF position if
you will be away from your home for an extended period of time.
•
Placing the slide switch in the OFF position also functions as a
safety "lock out" by both turning the system OFF and rendering the
transmitter inoperative.
INSTALLATION INSTRUCTIONS
DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER. THIS WILL BURN OUT
THE RECEIVER. FOLLOW INSTRUCTIONS FROM MANUFACTURER OF GAS VALVE FOR CORRECT
WIRING PROCEDURES. IMPROPER INSTALLATION OF ELECTRIC COMPONENTS CAN CAUSE
INSTALLATION
The remote receiver can be mounted on or near the fireplace hearth. PROTECTION FROM EXTREME HEAT
IS VERY IMPORTANT. Like any piece of electronic equipment, the remote receiver should be kept away from
temperatures exceeding 130º F inside the receiver case. Battery life is also significantly shortened if batteries
are exposed to high temperatures.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or
under the fireplace, behind the control access panel. Position
where the ambient temperature inside the receiver case does
not exceed 130º F. NOTE: Black Button is used on Hearth Mount
Applications.
DAMAGE TO GAS VALVE AND REMOTE RECEIVER.
WARNING
25
Remote Receiver
Wire terminals
Reveiver
Slide
Button
LEARN
REMOTE
