Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL OPERATION
Model SPK300L
1. STOP! Read the safety information on the pages before this.
2. Open the lower access panel located below the fireplace screen.
• Set receiver switch to "ON" position (See Fig. 17).
3. Turn control knob clockwise
4. Wait five (5) minutes to clear out any gas. Then smell for gas, including
near the floor. If you smell gas, STOP! Follow "B" in the safety information
on the pages before this. If you don't smell gas, go to the next step.
5. Push in slightly and turn control knob counterclockwise
"PILOT" position (See Fig. 17). Depress control knob.
6. With control knob depressed, push down on the ignitor button until the
pilot lights. The pilot is located behind the fireplace screen, centered near
the rear of the burner (See Fig. 18).
7. Keep control knob depressed for (30) seconds after pilot lights. Release
control knob.
• If the control knob does not pop up when released, stop and immediately
call a qualified service technician or gas supplier.
• If pilot goes out repeat steps 3 through 7. Wait (1) minute before attempting
to light pilot again. If after several tries the pilot still goes out, turn the
gas control knob clockwise
service technician.
8. Turn control knob counterclockwise
9. To use the included thermostatic remote control, set receiver switch to
the "REMOTE" position (See Fig. 19). Press the ON button to turn on the
remote to ignite the main burner. Refer to the remote control instruction
manual on the next page for "MODE" and "SET" functions.
Model SPK300L
1. Set thermostat (Transmitter) to the lowest setting.
2. Press the OFF button on the remote control.
3. Push in slightly and turn control knob clockwise
to the "OFF" position (See Fig. 17).
to the "OFF" position and call a qualified
to the "ON" position.
TO TURN OFF GAS TO APPLIANCE
21
Low/ Abnormal Pilot Flame
to the
to the "OFF" position.
LEARN
OFF
REMOTE
ON
Fig. 17 - Receiver
& Control Knob
Thermocouple
Fig. 18 - Pilot
LP Pilot Assembly
ON
OFF
Fig.19 - Remote
