Idiomas disponibles
Idiomas disponibles
If power is required for the camera, the connection must be hardwired:
• This can be done at the radio using the Red wire for power, and the Black wire for ground.
• The Black Ground wire from the camera will have to be extended and routed to the front
with the video RCA. (Figure A)
Note: Remove the glovebox to route the camera RCA to the dash.
(Figure A)
USB REPLACEMENT & CAMERA INSTALLATION
If equipped with TPMS, and you wish to add the visual to the Pioneer Radio screen:
• Route the LD-CAN3T harness behind the glovebox and connect to the junction pictured
below. Any available spot can be used. If no spots are available, unplug one of the 2-pin
connectors and connect to the other end of the LD-CAN3T. This will connect to the LD-CH5-
PIO 2-Pin labeled "CAN 3".
If you do NOT have the LD-CAN3T:
• Connect Brown/White from the LD-2PIN-CAN to one of the 2-pins Yellow wire, then Brown
to the other wire in the 2-Pin. This will connect to the LD-CH5-PIO 2-Pin labeled "CAN 3".
Brown/White = CAN LOW
Brown = CAN High
Note: The glovebox must be removed to access this connection. Refer to photo for connection point.
(Figure B)
(Figure B)
11
REV. 10/14/22 INSTAXPIO-JL1
