Idiomas disponibles
Idiomas disponibles
1. After reassembling the spare tire bracket,
plug the brake harness back into the tailgate
and run the wire through the tailgate using
zip-ties. Follow the current run of the wiring
in the tailgate to make sure the panel will fit
properly once the wires are run.
2. Run the wire through the truck bed and into
the vehicle.
3. Once inside the vehicle, power the camera via
a reverse trigger from the taillight.
a) Connect the RED wire to the reverse trigger.
Note: There is a RED wire located at the
opposite end of the harness with the YELLOW
RCA, if the user wants the camera powered
with an accessory circuit.
b) Connect the BLACK wire to a chassis ground.
4. Run the wire down the length of the vehicle
carefully.
Attention: Make sure not to run the wire near
any objects that emit extreme heat or could
catch or pinch the wire.
10
WIRING
