Idiomas disponibles
Idiomas disponibles
8. Drill a 3/4-in. hole large enough to clear the closed flaps of the butterfly nut on the toggle bolt (BB) into each of the
screw locations marked on the ceiling.
9. Install a toggle bolt (BB) in each drilled mounting hole, but do not tighten fully.
10. Align the 2 mounting keyholes on the fixture housing (A) with the 2 toggle bolts (BB) in the ceiling, allowing the bolt heads to
come through the large ends of the keyholes.
11. Slide the housing (A) until the heads of the toggle bolts (BB) slide into the narrow ends of the keyholes.
12. Finish tightening the toggle bolts (BB) until the fixture housing (A) is tightly secured to the mounting surface.
NOTE: The toggle bolts (BB) are only to be used for mounting the fixture to plaster or drywall surfaces. If mounting to
another type of surface, please replace the toggle bolts (BB) with the appropriate type of mounting hardware (not included).
13. Reconnect the terminal ground wire from the wire way cover to the housing (A).
A
14. Reattach the wire way cover to the wrap light housing (A) by squeezing the wire way cover and inserting the tabs into the
openings in the housing (A).
NOTE: If electrical connections are inside the wrap light housing (A),
ensure the wire connections are covered by the wire way cover.
15. Close the diffuser (B).
A
16. Move the fastened lock in both sides to Lock position.
17. Align the slots and press down the end caps (C).
HH
B
E
B
BB
Lock
Slot
3
C
1
3
2
3
