interrupted at any time by turnin the timer (6) to the startin position.
Remove the arment from the nylon balloon and han er (1).
Pull the mains plu out of the plu socket and allow the device to cool down completely.
MAINTENANCE AND CLEANING
Unplu the mains plu out of the plu socket and allow the device to cool down com- pletely before
doin any cleanin !
Never immerse the device, the mains cable or the mains plu in water or other liquids!
Do not use any corrosive or abrasive cleanin a ents or cleanin pads to clean the device. These can
dama e the surface.
Clean the device and the nylon balloon if necessary with a sli htly damp cloth and a little mild deter ent
if required. Then wipe down fully with a dry cloth.
Allow all parts to dry completely before you put them away.
Store the device in a clean, dry place that is protected from sunli ht and is not acces- sible to children
and animals.
Troubleshootin Guide
PROBLEM
The device does
not work. The LEDs
do not li ht up.
Unusual noises
The device
switches o
suddenly.
Odour produced
POSSIBLE CAUSE
• Is the mains plu inserted in the plu socket correctly? Correct the fit of
the mains plu .
• Is the plu socket defective? Try another plu socket.
• Check the fuse of the mains connection.
• Is the device switched on? Set the timer (6) to a time.
• Are the ventilation slots (5) covered up or blocked? Free up the ventilation
slots (5).
• Are the ventilation slots (5) covered up or blocked? Free up the ventilation
slots (5).
• The device has an automatic safety switch-o function. It switches o
automatically if it overheats. Allow the device to cool down and switch it on
a ain.
• Has the device fallen over? The device has a protective switch that is
activated if the device falls over. Set the de- vice up a ain and switch it back
on.
• Has the set time elapsed? Set the timer (6) to the time you want a ain.
• You mi ht notice a sli ht odour caused by production res- idues the first
time you use the device. However, this is harmless and will cease as you use
the device.
15
