ASSEMBLY
Put the piece (11) on the telescopic bar and ti hten the screws to the indicated hei ht.
Plu the telescopic rod (2) into the recess on the top of the motor unit (4).
Assemble the win s of han er with screw, place the han er (1) onto the telescopic rod (2). When you do
this, make sure that the sli ht bend in the han er (1) points forwards.
Attach the nylon balloon:
Pull it over the han er (1). When you do this, make sure that the side with the hole line points forwards.
Put the neck at the top over the collar section (9) on the han er (1).
Pull the lar e elastic cord at the bottom over the mountin flan e (7).
The device is disassembled in the reverse order.
CAUTION: Only place the device on a stable, flat, moisture-resistant and heat-resistant surface.
Caution! Hot surface! The motor unit / telescopic rod will become hot durin use. You should therefore
not touch it durin or shortly after use.
It is essential that you follow the care labels for the textiles to be dried!
Never cover up the ventilation slots and do not insert any objects into them.
HOW TO USE
Set the hei ht you want. To do this, open the screw (8), pull out the telescopic rod (2) and then close the
screw (8) a ain
If you have not already done so, pull on the nylon balloon (see the "Before Initial Use" chapter, "Assembly"
section).
The nylon balloon should sit immediately below the mountin flan e (7) so that it can fully inflate.
Pull the arment which is to be pressed over the nylon balloon and the han er (1) and do up the buttons
if necessary. Make sure that
– the collar is fitted over the collar section (9) on the han er (1),
– any button strip is over the hole line on the nylon balloon,
– the arms of the nylon balloon fit properly in the sleeves of the arment and are not twisted or scrunched
up,
– all buttons on the arment (includin on the sleeves) are done up.
Insert the mains plu into an easily accessible socket.
Turn the timer (6) clockwise and set it to the len th of time you want.
Once the nylon balloon has inflated, strai hten out the arment and smooth it down a ain.
SPRAYING
When the set time elapses, the device switches o automatically. The dryin / pressin process can be
14
