Idiomas disponibles
Idiomas disponibles
User Servicing Instructions
1. Using the product controls, turn off the appliance.
2. Grasp the plug (not the cord) and disconnect from the outlet.
3. Risk of Fire. Replace fuse only with 2.5 Amp, 125 Volt fuse as approved by
Consumer Service. For an authorized replacement fuse, please contact
Consumer Service.
4. Once the replacement is received, use a small flat-head screwdriver to slide
open the fuse cover (located on the plug) (See Fig. A).
5. Remove fuse by using the screwdriver to gently lift each end of the fuse (See
Fig. B).
6. Install the replacement fuse by using the screwdriver to gently push each metal
end of the fuse into the receptacle one at a time. Do not push on the center of
the fuse—it is fragile and may break.
7. Slide the fuse cover closed using the screwdriver. When closed, the cover should
fit completely in the plug. No part of the cover should stick out (See Fig. C).
8. Plug your appliance into the outlet and turn the power on.
9. If the replacement fuse blows, a short-circuit may be present and the
product should be discarded or returned to an authorized service facility for
examination and/or repair.
Fig. A
Fig. B
Risk of fire. Do not replace attachment plug. Contains a safety device (fuse, AFCI,
LCDI) that should not be removed. Discard product if the attachment plug is damaged.
8
English
Fig. C
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Contact Sharper Image Consumer Service or dealer or an experienced radio/
TV technician for help.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
English
9
