Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Connection to the compressed air line
1. Remove the plastic cap from the compressed air inlet (4);
2. Insert and tighten the air hose coupling (5) into the air inlet;
3. Attach the coupling to the air hose.
Changing and inserting drills and bits
Never insert or change the drills and bits while the
appliance is running. Disconnect the appliance from the
compressed air system before doing so.
1. Turn the chuck (1) sleeve clockwise to open the chuck claws
so that drill or bit can be inserted.
2. Insert the drills or bit all the way in;
3. Turn the chuck sleeve counter clockwise to adjust the drill or
bit;
4. Insert the key (6) into one of the holes and tighten clockwise
until the drill or bit is properly fixed.
When using screwdriving bits always use a magnetic bit holder.
OPERATING INSTRUCTIONS
Start and stop
Check the working pressure and adjust in accordance with
the technical data (Pmax < 6.2 bar).
1. To switch the pneumatic tool on, press the "ON/OFF" switch
(2);
2. To switch off, release the "ON/OFF" switch.
Direction of rotation
Do not change the direction of rotation while the
pneumatic drill is running, it can cause serious damage to
the appliance. Always check the direction of rotation before you
start operating it.
1. To select the direction of rotation, use the forward/reverse
lever (3).
▪ For clockwise rotation, set the lever to the upper position
(F);
▪ For counter clockwise rotation, set the lever to the lowest
position (R).
Setting the speed
The rotation speed can be controlled by the "ON/OFF" switch
(2). The rotation speed increases as you press the "ON/OFF"
switch.
You reach the maximum speed when you fully press the
"ON/OFF" switch.
25
