Idiomas disponibles
Idiomas disponibles
PICTURE 12
SETTING INTERNAL TEMPERATURE
Temperature setting of your product has made at the factory in a manner that it is
operated under the most appropriate conditions.
When you run your product at factory set value, you get the best result in terms of both
the performance and energy consumption.
Run your device empty for at least three hours. Therefore, inside of your product will
be cooled down in the best way. It is recommended to place the thermostat in position
4
WARNING!
An evaporator without ice, will always work at high efficiency.
Water from the evaporator falls onto the drip tray in the compressor section.
Although the hot gas evaporates water, it is recommended to check and clean it
once a month.
CAUTION!
If your product is stored indoors after it has been turned off:
Do not cover it with plastic material. Plastic will cause odor and moisture retention in
your product as it prevents ventilation. Lack of ventilation can result in corrosion.
DEFROSTING
Your product can be defrosted, manually.
If there is excessive ice on device, this will lead decrease in the cooling capacity and
increase in energy consumption.
If the ice is too thick, place the products inside of your device to another suitable
environment that prevents them to get spoiled.
PICTURE 13
52
PICTURE 14
