Idiomas disponibles
Idiomas disponibles
Positioning
Possible placement positions:
In a way that the back side alone is opposite to the wall; be careful that there is a
1.
gap of 150 mm (15 cm) between the wall and your device. (Picture 7)
In a way that is place to a corner; when you place it to a corner, leave a gap of 150
2.
mm (15 cm) behind. You can lean the side, corresponding to the corner, to the wall.
The most important point to be considered in all cases of product placement is not to
obstruct ventilation of the compressor assembly.
Without exposing your product to any slope, place and operate it in a manner that it is
on its feet or wheels.
The freer the compressor assembly ventilation is, the better the device will run.
Installation
Before positioning, remove and disassemble all packaging materials and bottom
wooden pallet of the product. (It may be necessary to lift your device for removing the
bottom pallet).
Insert the replacement parts inside your product according to the installation
instructions. Only use genuine spare parts. Please consult to salesperson for minimum
period during which spare parts, are available
Inauthentic spare parts may constitute danger for you and damage your product.
Place the product anywhere you desire. Consider the placement rules written in the
manual while positioning the product.
Balance your product in width and in depth by means of a water gauge. Please perform
optional balancing operation by means of the adjustable feet at the bottom front of your
product. (Picture 8)
PICTURE 7
PICTURE 8
50
