Jocel JEXF-014559 Manual De Instrucciones página 45

Idiomas disponibles

Idiomas disponibles

ADVICE BEFORE USE AND SAFETY WARNINGS
WARNING!
Do not place your product to a place exposed to direct sunlight or influence area of the
heat sources such as stove, radiator core, oven, cooker, radiant and infrared.
Otherwise, this may cause performance decrease, damage of your product or make it
become dysfunctional. (Picture 1)
Your product is set for operating at mains power of 230V~50 Hz. Using your product
with a different voltage may cause it become dysfunctional and fire. (Picture 2)
JOCEL is not responsible for the failures and material damages that may occur in case
of using without grounding.
Electrical installation must conform to national regulations.
There must absolutely have a circuit breaker in the electrical installation for preventing
the risks of electrical shock and fire.
Place the device in a damp-free place with unobstructed air circulation.
You must clean inside your product before the first use.
After placing your device to its place, wait for one (1) hour without moving it before
starting using.
If your device is installed under very cold weather conditions, then the waiting period
must be at least two (2) hours before starting to operate it.
In case of prolonged blackouts, do not open the door of your products for preventing
heat loss.
If you do not use your device or leave it empty for a short time, do not unplug it for
saving energy. Otherwise, more energy will be consumed for re-cooling your product.
In products, the doors of which are left opened or opened and closed continuously,
frost deposit will increase and no cooling operation will be carried out. Thus open the
doors of your product only when needed. Make sure that the doors are closed if not
required.
Unplug your product in case of sudden blackouts. For starting again, plug in your
product 20 minutes after the electricity is supplied. High voltage occurring at the
moment of electricity supply may cause damage of your product and fire.
Do not allow wild animals and pets to enter into your product or walk around it. It may
damage your product or cause death and injury of the animals. Furthermore, wild
animals and pets may cause fire by giving harm to the electrical installation.
Your device does not have any sterilizing effect on the microorganisms. Therefore, it is
necessary that the foodstuff you place into your product must conform to the hygiene
standards and packaged. Otherwise, microorganisms reproducing in foodstuff may
pose a threat for your health.
44
loading