Desoutter DJS Manual De Instrucciones página 7

Installation
Installation instructions
The DJS simulates the joint behavior. Install the DJS on a PST – Pulse Static Transducer to test power and
impulse tools.
Each DJS simulates a specific stiffness as described in its torque/angle characteristics.
The DJS is identified by the two colored rings.
For more information about the PST – Pulse Static Transducer, refer to "PST – Pulse Static Transducer
Product Instructions" (Desoutter User Guides are available at http://www.desouttertools.com/resource-centre).
To install the DJS on the PST – Pulse Static Transducer, do the following:
If necessary, for PST – Pulse Static Transducer models with a capacity over than 10Nm, loosen the
1.
lever.
Insert the DJS into the socket of the PST – Pulse Static Transducer.
2.
For PST – Pulse Static Transducer models with a capacity over than 10Nm, tighten the lever.
3.
WARNING Risk of injury
Before starting a test, make sure that the DJS is correctly installed on the PST – Pulse Static
Transducer.
1
03/2021
EN
2
7 / 101
Product Instructions
3