Idiomas disponibles
Idiomas disponibles
Cleaning and maintenance
We recommend cleaning the appliance after each use. This will prevent the food that is stuck to the
cooktop from heating up and damaging the glass surface.
Daily exterior cleaning
Clean the appliance using a damp cloth and a mild detergent, such as dish soap.
Wipe the appliance dry with a paper towel or a cloth for best results.
For heaviliy polluted stainless steel surfaces use a stainless steel cleaner. Clean according to the
cleaner instructions. If possible, wipe along direction of the grain.
Cleaning control panel
To avoid damage to the cooktop controls, do not use steel wool, abrasive cleaners or oven cleaner.
If you remove knobs during the cleaning of the control panel, be careful not to move the knob
gasket from its assembled place.
If you move the gasket, you can install it back in the right place by yourself.
Cleaning glass cooktop
Immediately remove any food remains, burnt grease, sugar or stubborn stains from the cooktop
using a scraper, even if the cooktop is still hot! Spills of sugar or food with high sugar content can
permanently damage the glass-ceramic surface.
After you have removed the stubborn stains from the glass, use the daily cleaning steps to clean
the burner.
WARNING!
Do not use abrasive cleaning agents because they can cause scratches. Do not use
steelwool, scourers or any type of sharp objects to clean the appliance.
WARNING!
The cooktop could still be very hot from the cooking process. Do not touch the appliance
surface directly. Immediately after the end of the cooking process, you can use protective
gloves or mittens to prevent burns.
EN 30
Hold the scraper (not included) at the correct angle (45° to 60°)
relative to the cooktop. Gently slide the scraper across the glass
surface to remove the dirt. Make sure the plastic handle of the scraper
(in some models) does not come into contact with a hot cooking
zone. Do not press the scraper perpendicularly against the surface.
Be careful not to scratch the cooktop surface with the corners of the
scraper blade. This could result in permanent scratches on the
surface.
