Idiomas disponibles
Idiomas disponibles
4. To clean the foam air filter, do the steps that follow.
a) Remove the foam air filter from the air filter
cartridge.
b) Clean the foam air filter with a weak detergent.
c) Let the foam air filter become dry.
d) Install the foam air filter around the air filter
cartridge.
5. To clean the paper air filter, do the steps that follow.
a) Hit the paper air filter against a hard surface.
b) Blow with compressed air from the inner side of
the paper air filter.
CAUTION:
does not become clean, the paper air
filter must be replaced.
6. Install in the opposite sequence.
To examine and replace a spark plug
1. Open the engine cover.
2. Remove the spark plug cap and clean around the
spark plug.
3. Remove the spark plug with a spark plug wrench.
4. Examine the spark plug. Replace it if the electrodes
are burned or if the insulation has cracks or
damages. If the spark plug is not damaged, clean
it with a steel brush.
5. Measure the electrode gap and make sure that it is
Technical data on page 41 .
correct. Refer to
6. Bend the side electrode to adjust the electrode gap.
7. Put the spark plug back in and turn it by hand until it
touches the spark plug seat.
8. Tighten the spark plug with the spark plug wrench
until the washer is compressed.
9. Tighten a used spark plug ⅛ of a turn more, and a
new spark plug ¼ turn more.
CAUTION:
tightened correctly can cause damage to
the engine.
10. Attach the spark plug cap.
CAUTION:
engine if the spark plug or ignition cable
is removed.
26
If the paper air filter
Spark plugs that are not
Do not try to start the
To replace the main fuse
The main fuse is found in the fuse holder on the start
relay below the seat.
1. Fold the seat forward.
2. Remove the connector from the fuse holder.
3. Pull the main fuse from the fuse holder.
4. Replace the blown fuse with a new fuse of the same
Technical data on page 41 .
type. Refer to
If the main fuse blows again a short period after you
replace it, there is a short circuit. Repair the short circuit
before you operate the product again.
To charge the battery
•
Charge the battery if it is too weak to start the
engine.
•
Use a standard battery charger.
CAUTION:
charger or start booster. That will cause
damage to the electrical system of the
product.
•
Always disconnect the charger before starting the
engine.
To do an emergency start of the engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
Do not use a boost
1903 - 002 - 06.02.2023
