Idiomas disponibles
Idiomas disponibles
Changing the Sanding Pad
(Fig. 2, Fig. 3)
Observe for and replace damaged
sanding pad immediately. Using a
damaged sanding pad could cause a hazard.
Pull off the Sanding Sheet 14 and the Intermediate Pad
15. While grabbing the Sanding Pad 17, turn the screw 16
counter-clockwise to loosen completely and remove it. Attach
the new Sanding Pad 17 and retighten the screw by turning
it clockwise.
Note: For proper fit, the keyed hub on the sanding pad must
align with the keyed flange on the Sanding Head Output Shaft
21.
Fig. 3
16
17
21
Fig. 4
9
11
10
11
Assembly
8
10
7
-13-
Inserting and Removing Extension Tubes
(Fig. 4)
Use the Extension Tubes 10 when necessary. The effort re-
quired to perform the sanding operation is reduced when
working without the extension tube.
Note: A maximum of two extension tubes may be inserted.
Undoing the Connection between Sanding
Head/Handle Section/Extension Tube
(Fig. 1, Fig. 4)
1. Open the Clamping Lever 9 .
2. Open the Safety Hook 8 .
3. Pull the previously connected parts apart .
Fastening the Connection between Sanding
Head/Handle Section/Extension Tube
(Fig. 1, Fig. 5)
1. Slide the Sanding Head 11, Handle Section 7, and/or
Extension Tubes 10 into each other depending on the
required connection .
2. Close the Safety Hook 8 .
3. Push the Clamping Lever 9 until it is at a right angle to
the Sanding Head 11, Handle Section 7, or Extension
Tube 10 .
4. To avoid loosening during operation, firmly tighten the
Eccentric Screw 22 clockwise .
5. Close the Clamping Lever 9 by pressing it back in place
.
9
10
11
7
8
7
10
