Idiomas disponibles
Idiomas disponibles
Disconnect power cord from tool before making any assembly, adjustments or changing acces-
sories. Such preventative safety measures reduce the risk of starting the tool accidentally.
Changing the Sanding Sheet
(Fig. 2)
To remove the Sanding Sheet 14, lift it from the side and
pull it off the Intermediate Pad 15. Remove any dirt or debris
from Intermediate Pad 15 with a brush before attaching a
new sanding sheet. Use hook and loop style sanding sheets
to properly secure to Intermediate Pad 15, press the Sanding
Sheet 14 firmly onto the underside of the Intermediate Pad
15.
To ensure optimum dust extraction, make sure that the
punched holes in the Sanding Sheet 14 are aligned with the
punched holes in the Intermediate Pad 15 and the drilled
holes in the Sanding Pad 17.
Note: An Intermediate Pad 15 is not required when working
with the medium-hard sanding pad; the Sanding Sheet 14 is
attached directly to the Sanding Pad 17. In all other cases, the
change is performed as described here.
Fig. 2
14
15
17
Assembly
Selection of the Sanding Pad
Soft Sanding Pad Set (GTR801)
• For universal use on flat and curved surfaces.
• The set consists of a soft sanding pad and an intermedi-
ate pad.
The sanding pad may only be used with an intermediate pad.
Medium/Hard Sanding Pad (GTR802)
• High material removal rate, ideal for hard plaster and
removing old wall paints
• For use on flat surfaces
• Optimal suction support makes work easier when using
a dust extractor.
Changing the Intermediate Pad (GTR800)
(Fig. 2)
An Intermediate Pad 15 must always be used when working
with the soft sanding pad (included with the drywall sander).
To remove the Intermediate Pad 15 lift it from the side and pull
it off the Sanding Pad 17.
Remove dirt and dust from the Sanding Pad 17, e.g. with a
paintbrush, before attaching a new intermediate pad.
The surface of the Sanding Pad 17 is fitted with a hook-and-
loop fastening, allowing intermediate pads to be secured
quickly and easily.
Press the Intermediate Pad 15 firmly against the underside of
the Sanding Pad 17.
To ensure optimum dust extraction, make sure that the
punched holes in the Intermediate Pad 15 are aligned with
the drilled holes in the Sanding Pad 17.
-12-
