Denver CRP-616 Manual De Instrucciones página 14

THE LED DIGITAL CLOCK AND THE PROJECTION
TIME SETTING FOR PROJECTION UNIT
- To preset the HOURS, press simultaneously the HOUR Button (24)
and the TIME button (25). Keep them pressed until the hour digits
to be preset are displayed.
- To preset the MINUTES, press simultaneously the MINUTE button
(23) and TIME button (25). Keep them pressed until the minute digits
to be preset are displayed.
- Focus setting: Adjust the projection clock brightness/focus by turning
the brightness/focus adjustment wheel (26) until the projected time is
clearly shown on the ceiling or wall.
NOTE: PROJECTS TIME IMAGE ON THE CEILING OR WALL OF A
DARKENED ROOM.
MAXIMUN PROJECTION DISTANCE IS 3-9 FEET.
The power cable/disconnect device shall remain easy to operate/
disconnect
Electric and electronic equipment contains materials, components and substances that
can be hazardous to your health and the environment, if the waste material (discarded
electric and electronic equipment) is not handled correctly.
Electric and electronic equipment is marked with the crossed out trash can symbol, seen
below. This symbol signifies that electric and electronic equipment should not be disposed
of with other household waste, but should be disposed of separately.
All cities have established collection points, where electric and electronic equipment can
either be submitted free of charge at recycling stations and other collection sites, or be
collected from the households. Additional information is available at the technical
department of your city.
CLOCK MUST BE SET SEPARATELY
ALL RIGHTS RESERVED
DENVER ELECTRONICS A/S
www.facebook.com/denverelectronics