Idiomas disponibles
Idiomas disponibles
to operate the grill.
Always bear in mind that the housing
surfaces as well as the heating element
and the grill rack become very hot during
operation. Even aft er the heating element
is switched off , it must not be touched until
it has suffi ciently cooled down - there is
otherwise a severe danger of burns.
To avoid the risk of electric shock, the
heating element and the power cord must
not be immersed in liquid or even allowed
to come into contact with it.
Do not allow the power cord to touch any
hot parts of the appliance.
Th e power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
Always remove the plug from the wall
socket
-
aft er use,
-
in case of any malfunction, and
-
during cleaning.
Th e use of an extension-lead reel causes
a loss of power, possibly combined with a
subsequent heat build-up in the cable. It
is therefore necessary to unwind the cable
completely if a cable reel is used. Make
sure that the reel is approved for outdoor
use by the manufacturer.
Th e appliance is not intended to be
operated by means of an external timer or
separate remote-control system
Before carrying, transporting or storing
the grill, ensure that is has suffi ciently
cooled down. Pour out any remaining
water aft er use.
Ensure that the grill is not stored outdoors,
or in any other location where it might be
subjected to extremes of temperature or
high humidity.
No responsibility can be/will be accepted
if damage results from improper use, or if
these instructions are not complied with.
Th is barbecue grill is intended for
domestic use only and not for commercial
applications.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
customer
service
address can be found in the appendix to
this manual.
Grill with additional base stand:
Assemble the base stand according to the
schematic diagram supplied, and then
place the grill onto the stand. Th e small
feet under the grill connect with the
tops of the vertical legs of the base stand.
Ensure that the grill and base stand are placed
in a safe and stable position. Th e power cord
should be routed in such a way that no one is
likely to trip over it.
Heating element
Th e junction box contains a safety switch.
Place the heating element into the grill pan.
Th e safety switch is activated automatically
when the heating element has been properly
fi tted. If not fi tted correctly, the appliance can
not be switched on.
Before using for the fi rst time
–
Remove any packaging materials from the
appliance.
–
Clean the grill rack and grill pan with
warm soapy water.
–
Grill assembly:
1. Place the heating element into the grill
pan.
2. Fit the grill rack on top.
3. If required, additional accessories may
be fi tted according to the diagram
shown in the instructions.
–
Fill the grill pan with water up to the
‚Max' marking.
–
Let the grill heat up for approximately 5
minutes without any food on the rack. Th is
will lessen the smell typically encountered
when fi rst switching on a new grill (a slight
smell and a little smoke may be emitted -
ensure suffi cient ventilation).
11
departments.
Th e
