Idiomas disponibles
Idiomas disponibles
CHARGING INDICATOR
Light
Red on
Green on
B) TO INSTALL OR REMOVE THE BATTERY
PACK
Depress the battery pack release button firmly first and
then slide the battery pack out from your tool. (See Fig. B1)
After recharge, slide it into the tool. A simple push and slight
pressure will be sufficient. (See Fig. B2)
OPERATION
1. INSERTING AND REMOVING DRILL BIT
TAKE CARE THAT THE DUST PROTECTION
CAP IS NOT DAMAGED WHEN CHANGING
BITS.
— INSERTING (See Fig. C1)
Clean and lightly oil the bit before inserting. Insert the
dust-free bit into the bit holder with a twisting motion until
it latches.
The bit locks itself. Check the locking by pulling on the tool.
— REMOVING (See Fig. C2)
Retract back the bit holder locking sleeve and pull out the
bit.
WARNING！Your new Rotary Hammer generates
powerful forces to get your job done quickly and
effectively. These forces may cause inferior quality SDS bits
to break and jam in the chuck， We therefore recommend
that only high quality SDS bits be used with this tool.
2. ON/OFF SWITCH WITH VARIABLE SPEED
CONTROL (See Fig. D)
Depress on/off switch to start and release it to stop your
tool. The on/off switch is also a variable speed switch that
delivers higher speeds with increased trigger pressure.
Speed is controlled by varying the pressure applied to the
switch.
3. SWITCH LOCK (See Fig. D)
The switch trigger can be locked in the OFF position. This
helps to reduce the possibility of accidental starting when
not in use. To lock the switch trigger, place the direction of
rotation control in the center position.
18
Status
Charging
Fully Charged
4. FORWARD AND REVERSE ROTATION
CONTROL (See Fig. E1, E2 )
With the drill pointing away from you, push the forward/
reverse-lever to the left for forward rotation. Push the
forward/reverse-lever to the right for reverse rotation.
WARNING: Never change the direction of rotation
while the tool is rotating, wait until it has stopped.
5. FUNCTION MODE SELECTION (See Fig. F)
The operation of the gearbox for each application is set with
the function mode selection switch. To change between
functions, depress the unlocking button (a) and rotate the
selector to the desired operating mode.
For simultaneous drilling and impacting of concrete or
masonry, choose the Hammer drilling position.
For drilling into steel, wood and plastics choose the Rotary
drilling position.
WARNING: The operating mode selector switch
may be actuated only at a standstill.
6. LED LIGHT
To turn on the light, press the on/off switch and make sure
the forward/reverse rotation control is on right/left position.
When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed
area.
7. DISPOSAL OF AN EXHAUSTED BATTERY
PACK
To preserve natural resources, please recycle or
dispose of the battery pack properly. This battery
pack contains Li-ion batteries. Consult your local
waste authority for information regarding available recycling
and/or disposal options. Discharge your battery pack by
operating your drill, then remove the battery pack from
the drill housing and cover the battery pack connections
with heavy-duty adhesive tape to prevent short circuit and
energy discharge. Do not attempt to open or remove any of
the components.
WORKING HINTS FOR
YOUR TOOL
If your power tool becomes over heated, set the speed
to maximum and run no load for 2-3 minutes to cool the
motor. SDS-plus tungsten carbide drill bits should always be
used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
condition. Where possible use a pilot hole before drilling a
large diameter hole.
EN
