Prevention Of False Alarms - DeWalt DS505 Manual De Instrucciones

• MOBILELOCK TM is a Trademark of the SITELOCK LLC. All
other trademarks in this manual are the properties of their
respective owners.
PRODUCT OVERVIEW
DS505 Extended Run-Time Adapter
The DS505 adapter is used to protect remote storage containers
and equipment.
• Uses four (4) standard D-size alkaline batteries (no external
power source needed)
• Extends the run-time up to three months (requires fewer battery
recharges)
DS510 Indoor Motion Detector
The DS510 indoor motion detector is used to protect enclosed
areas, trailers and climate-controlled storage spaces.
CAUTION: POTENTIAL EQUIPMENT MALFUNCTION OR
FAILURE. This equipment is intended for indoor use only. Do not
use near water. Damage to the equipment may occur. Equipment
shall not be exposed to liquids.
• Low-current motion detector is highly sensitive to moving heat
sources.
• 50 ft. (15.24 m) range; looks for movement across detection
zones
• Advanced digital scanning to recognize "human signatures."
• Increased immunity to outside interference such as radio
frequency interference (RFI), vibration, static, lightning, ambient
temperature changes, and other common causes of false
alarms
The DS510 signals an alarm condition to the MOBILELOCK
when motion is detected by the sensor. If the MOBILELOCK
is armed and the motion detector is enabled, alarm notification is
sent.
TECHNOLOGY OVERVIEW

Prevention of False Alarms

The majority of alarms that occur are false. These situations
happen everyday due to user error, incorrect installation or
improper maintenance of the equipment. False alarms will limit the
responsiveness to the system and become a general inconvenience.
As the number of false alarms increases, authorities have become
less apt to respond to alarm systems due to this problem. Many
of these situations can be avoided by following some very simple
practices.
• Ensure all users are properly trained on the operation of the
alarm.
• Always turn off the alarm before entering protected area.
• Lock all protected doors, windows, or any other asset attached
to the equipment.
• Check that premises are cleared and assets secured before
setting the alarm.
• Turn off all noise sources: radios, compressors, generators,
heavy equipment, etc.
• Know how to cancel an alarm or disarm the equipment before
activating.
• Test the system on a monthly basis to ensure proper
functioning.
• Check cellular signal, battery strength and sensors regularly.
TM
unit
TM unit
2