Idiomas disponibles
Idiomas disponibles
USING YOUR CLEANER
1.
Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker. [5]
2.
To adjust the length of the telezoom tube hold the nozzle in place with your foot, pull the
telezoom trigger and raise or lower the handle to the most comfortable cleaning position.
[6]
3.
Select the type of surface to be cleaned by pressing the pedal in the nozzle.
Hard F
Carpet – Brushes are raised for the deepest clean.
4.
Switch the cleaner on by pressing the On/O
5.
Adjust the suction by sliding the suction regulator to the desired level.
6.
rewind button to wind the power cord back into the cleaner. [10]
7.
To store your cleaner adjust telezoom tube to the lowest height setting and park the
nozzle in the park position on the cleaner main body. [11]
ACCESSORIES
individual models. All accessories can be purchased separately from Hoover. (See Hoover
Spares and Consumable section).
3 in 1 Accessory – C
body. Reach into awkward areas by rotating the body. The 3 in 1 tool can be stored neatly
underneath the hose handle. [1]
Crevice Tool – For corners and hard to reach areas. [12]
Furniture Nozzle – For soft furniture and fabrics. [13]
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend the
brushes push the button on the body of the tool. [14]
Parquet Caresse Nozzle* – F
Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1W]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs
removal. [1U]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas, particularly suitable for allergen
removal. [1V]
(*Certain Models Only)
XarionFilterPro_union_pp.indd 2
[7]
[8]
[9]
On/O
zoom
[1X]
IMPORTANT: Do not use the turbo and mini turbo nozzles on rugs with long fringes, animal
hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush
is rotating.
CLEANER MAINTENANCE
Emptying the Dust Container
When the dust reaches the max level indicator in the container empty the dust container.
IMPORTANT: To maintain optimum performance do not allow the dust to sit higher than the
max level.
1.
Release the container carry handle by lifting the centre latch to detach the dust container
from the main cleaner and pull upward to remove. [15]
2.
Hold the dust container over a bin with one hand and with the other pull the dust
container catch to open the door and empty. [16]
3.
C
container carry handle down until the latch connects with the main body of the cleaner.
O
IMPORTANT: R
IMPORTANT:
To access the Pre-M
NOTE:
1.
2.
R
3.
4.
R
using warm water. Do not use hot water or detergents. Remove excess water from the
5.
R
2
[17]
O
[18]
[21]
GB
28-04-2010 16:29:49
