Idiomas disponibles
Idiomas disponibles
10. CHARGING PROCESS
To charge a vehicle, follow these steps:
1. If the charger is orange (locked), activate it from the APP
or by holding up the RFID card (depending on the model).
The LEDs will turn from orange to green.
2. Connect the ends of the cable to the charger and the vehicle.
3. Check that the LEDs turn from green to solid blue, which
indicates that charging has begun successfully.
4. When the vehicle is completely charged, the LEDs will
begin to blink blue.
5. To finish charging, hold the RFID card near the antenna
symbol on the unit.
6. Disconnect the vehicle.
11. AVAILABLE ACCESSORIES
11.1. Card reader.
All SM34 units allow a card reader to be added as an accessory so
the recharging station can be activated with a card. 2 RFID cards
are included are included with the reader accessory. For more
information, please see the card reader manual.
11.2. Bluetooth communications module.
All SM34 units allow a Bluetooth communications module to be added
as an accessory so the recharging station can be activated with a card.
For more information, please see the communications module manual.
11.3. Home dynamic load manager.
A dynamic load manager can be added to balance the power of the
charging point, prioritizing other consumption in the installation.
There are different versions depending on whether the installation
is single-phase or three-phase. For more information, please see the
manual on home dynamic load management.
11.4. Photovoltaic dynamic load manager.
A dynamic load manager can be added to installations that generate
energy with photovoltaic panels in order to optimize the power of the
recharging point by taking the amount of energy being generated
into account. For more information, please see the manual on home
dynamic load management.
11.5. Vertical mounting column
In locations where the unit cannot be wall mounted, a column can
be purchased for vertical mounting. There are versions for a single
charger or for two chargers.
16
