Idiomas disponibles
Idiomas disponibles
INSTALLATION AND ELECTRIC DIAGRAM
CONCRETE
BASE
CORRECT INSTALLATION
USE OF EXTENSIONS
When using an extension cable, double check you are using the gauge that will suffice to transport the current
the pump needs. A lower gauge cable will cause power drops in the line resulting in power loss and motor
overheating
The following table shows the right size to be used depending on cable's length and the ampere capability
shown in the nameplate. If you have any doubts use the next higher gauge. Remember, the lower the gauge,
the heavier the cable will be. Double check the extension cable is in good repair and it has a ground conductor.
Minimum gauge for extension cords (AWG)
(For 127V~ only)
Ampere Capacity
(1) Is allowed to use only when the extensions have a built in over current protection artifact.
(2) One conductor shall be a ground conductor. All the conductors are the same designation (gauge) including
the ground one.
Reference: NMX - J - 195 - ANCE
JOINT NUT
SUCTION
PIPES
SUPPORT
SAND PIT
PICHANCHA
VALVE
MOTOR JUNCTION BOX
More than
Up to
0 A
10 A
10 A
13 A
13 A
15 A
15 A
20 A
MINIMUM LEVEL
1.6 ft
127 V~
SWITCH
FUSE
(2)
From 5.9 ft
No. of
up to 49.2 ft
conductors
3
18 AWG (1)
3
16 AWG
3
14 AWG
3
8 AWG
REGULATE VALVE
INCORRECT INSTALLATION
Extension Gauge
Higher than
49.2 ft
16 AWG
14 AWG
12 AWG
6 AWG
4
