Idiomas disponibles
Idiomas disponibles
Assembly - Standard Ceiling Mount
1
Preparation for standard mounting
□
Remove the canopy bottom cover (C) from the canopy (B) by
turning the bottom cover counterclockwise until it unlocks.
□
Loosen the two canopy screws (PP) located in the bottom of the
mounting bracket (A), and turn the canopy counterclockwise to
remove the mounting bracket (A) from the canopy (B).
A
PP
B
C
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the two setscrews (ZZ) on the
collar on top of the fan motor assembly (E).
□
Align the holes at the bottom of the downrod (D) with the
holes in the collar on top of the fan motor assembly (E).
□
Carefully insert the hanger pin (BB) through the holes in the
collar and downrod (D). Be careful not to jam the hanger pin
(BB) against the wiring inside the downrod (D).
□
Insert the locking pin (CC) through the hole near the end of
the hanger pin (BB) until it snaps into its locked position.
□
Re-tighten the two setscrews (ZZ) on the collar on top of the
fan motor assembly (E).
2
Routing the wires
□
Route the wires exiting the top of the fan motor assembly (E)
through the center of the canopy bottom cover (C).
□
Make sure the opening of the canopy (B) is on top and insert
the ball/downrod (D) through the canopy (B).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
D
B
C
E
BB
7
Please contact 1-855-HD-HAMPTON for further assistance.
D
CC
ZZ
E
HAMPTONBAY.COM
