SWITCHING OFF THE DEVICE
1) Make sure all detergent is rinsed out of the machine.
2) Turn off the engine.
3) Turn off the water supply.
4) With the engine and water off, squeeze the gun trigger to release pressure
inside the unit.
NOTE: NEVER turn off the water supply before turning off the engine. This
could seriously damage the pump and/or motor.
WARNING! NEVER disconnect the high-pressure outlet hose from the machine
while the system is under pressure. To release the pressure, turn off the
engine, shut off the water supply and pull the trigger 2-3 times.
5) After each use, wipe all surfaces of the pressure washer with a clean, damp
cloth.
STORAGE
Do not store the pressure washer outdoors.
•
•
Do not store the pressure washer in an area where it may freeze.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE WASHER
a) Never use the appliance without water.
b) The pressure washer is not intended for pumping hot water. Never connect to
a hot water supply - this will significantly reduce the life of the pump.
c)
Never use the appliance without water for more than one (1) minute. The
resulting heat build-up will damage the pump.
d) Release the trigger before adjusting the nozzle pressure (high to low or low to
high). Failure to do so will shorten the life of the sealing rings in the lance.
3.4. Cleaning and maintenance
a)
Before each cleaning, adjustment or replacement of accessories, and also
when the unit is not in use, disconnect the main power plug, turn off the water
supply, release the pressure from the unit and cool it down completely.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all parts should be thoroughly dried before the device is
reused.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.