Idiomas disponibles
Idiomas disponibles
Figure 10 - Water inlet filter
3.3. Working with the device
SURFACE PREPARATION
Before cleaning with a pressure washer, it is important to prepare the surface. This is
done by removing unnecessary objects and making sure that all windows and doors are
tightly closed. In addition, make sure that all plants and trees adjacent to the area that
is to be cleaned are properly sheltered. The plants will not be sprayed with detergents
as a result.
PRE-RINSING UNDER HIGH PRESSURE
The next step is to spray the surface with water to remove any dirt that may have
accumulated there. This will allow the detergent to attack deeply embedded dirt that
has adhered to the surface. Before squeezing the gun trigger, set the nozzle to a wide
spray pattern and slowly adjust it to the desired spray pattern. This will help to avoid
spraying the surface with too concentrated spray, which could cause damage.
FINAL RINSE
Start the final rinse at the bottom and move it upwards. Make sure the surface is rinsed
thoroughly and that all detergent has been removed.
