Idiomas disponibles
Idiomas disponibles
n)
It is recommended that you wash and disinfect every day and as often as the
law in your area of use dictates.
Automatic cleaning of the dispenser:
•
Empty the dispenser of any remaining beverage.
Remove the dispenser covers.
•
•
Pour lukewarm water into the tanks of the dispenser.
Replace the tank covers.
•
•
Switch on the button (9) to start blending.
Allow the dispenser to run in agitation mode for a few minutes, and then
•
repeat all steps a few times to rinse the dispenser thoroughly. Repeat these
steps until the water coming out of the unit is clear.
After completing these steps, empty the water out of the unit, turn it off, and
•
disconnect it from the power supply.
CAUTION! The person performing the cleaning and disinfection operations
must wash and disinfect their hands to ensure proper cleaning and
disinfection.
Remove the unit's covers.
•
•
Unscrew the nut from the stem holding the lever in position, remove the stem
and slide the plunger out of the tap tube.
CAUTION! Remove any gaskets during cleaning to minimize the risk of bacterial
growth.
•
Remove the tank by pulling vertically upwards.
Remove the agitator by pulling upwards.
•
Remove the drip tray.
•
Wash the disassembled parts completely with warm water and dishwashing
•
liquid.
Rinse the parts with water and place them in the disinfectant solution for
•
approximately 15 minutes or for the length of time recommended by the
disinfectant manufacturer.
After the disinfectant bath, rinse the unit parts thoroughly with water and wipe
•
dry with a soft cloth.
•
Wash the entire unit with a mild detergent designed for cleaning food contact
surfaces.
Rinse the whole unit with a sponge soaked in water and then wipe it dry with
•
a soft cloth.
CAUTION! Do not assemble the unit until your hands have been thoroughly
washed and disinfected.
Using a lubricant for mechanical parts in contact with food in order to assemble
•
the unit correctly and avoid leaks and damage is recommended. Lubricate the
contact surfaces of moving parts with the lubricator.
Moisten the bottom of the reservoir where it meets the gasket with water to
•
facilitate assembly.
